Suzuki sds tool8/27/2023 (10) A"trigger" can be set up for the diagnostic data. The trigger is a function that starts recording the data from where the set value is exceeded (or comes short) for one or more data. This function can also record the timing to display the trouble code in the monitoring graph. (11) Active control is possible (such as secondary air solenoid drive, etc.). (12) The system can record the data of about 30 minutes of operation as well as driving data. (13) The system requires setting up an additional function to the onboard ECU and use of a special connector. The diagnosis system is applicable to the new models produced in and after May 2002 (AN 650 onward) and their model changes. This system is not applicable to those models that were produced earlier than the above.ĭata Monitor: Shows the present vehicle condition using a numerical or graph display.ĭTC inspection : Shows diagnostic trouble codes saved in ECU. Show failure data : Shows the vehicle condition before and after failure using a numerical display.Īctive control: Controls the vehicle temporarily from the computer.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |